PipeForge ISOAuto Take-Off
Pipe tool: drag to draw runs
Developed by Bryan Leurquin
Draw a run on the Build tab.
Cut lengths and the bill of material appear here as you go.
Developed by Bryan Leurquin

Butt-weld end prep (open root)

Bevel angle37.5° ± 2.5° (75° included)
Root face (land)1/16" (1.6 mm) nominal
Root opening (gap)1/16" – 3/32"

The 37.5° bevel is measured from the plane square to the pipe axis, so two prepped ends form a 75° included V. The land is the flat at the root that the root pass fuses through; too little burns back, too much leaves lack of penetration.

Fit-up & weld sequence

  1. Bevel both ends to 37.5° and dress a clean 1/16" land. Wire-brush bevel and 1" back to bright metal.
  2. Set the root gap with a spacer or rod tip (match it to your selected gap), align with line-up clamp; check hi-lo.
  3. Tack 3–4 places, feather (grind) the start/stop of every tack.
  4. Run the root pass; keep the keyhole consistent. Grind any suck-back before the hot pass.
  5. Hot pass to burn out root defects, then fill passes, then a slightly wider cap with even tie-in.
  6. Inter-pass clean (chip/brush) between every pass; control inter-pass temp on alloy/SS.

General guidance only. Actual bevel, land, gap, filler and pass sequence are governed by the qualified WPS for the material, wall thickness and process on your job.

Developed by Bryan Leurquin