PipeForge ISOThreaded Take-Off
Pipe tool: drag to draw runs
Developed by Bryan Leurquin
Draw a run on the Build tab.
Cut lengths and the bill of material appear here as you go.
Developed by Bryan Leurquin

NPT thread make-up

Take-off (center fitting)throw − makeup
Take-off (valve / coupling)OAL/2 − makeup
Makeup (this app)L1 + L3 (wrench-tight)

Makeup is how far the pipe disappears into the fitting at full wrench-tight assembly — ASME B1.20.1 hand-tight (L1) plus wrench (L3). For 1" NPT that's about 0.68", so a 1" 90° ell (throw 1.50") gives a 0.82" take-off. Shops that run a 7/8" take-off on 1" are using a slightly lighter makeup.

Cut & thread sequence

  1. Square-cut the pipe, then ream the inside burr — a missed burr chokes flow and snags.
  2. Thread with sharp dies and cutting oil; cut to a proper length so the last thread or two vanish (imperfect threads). Too long bottoms out, too short won't seal.
  3. Wire-brush the threads clean. Apply approved pipe dope and/or PTFE tape to the male threads only — tape wrapped in the thread direction, 3–4 wraps.
  4. Hand-tight, then wrench-tight the wrench turns (the L3 portion) — a few turns, size-dependent. Use a back-up wrench so you don't loosen the upstream joint.
  5. Don't over-torque; cracked fittings and split female threads come from muscle, not seal.

General guidance. Sealant choice (gas vs water), make-up torque and engagement are governed by code and the AHJ. Valve dimensions here are representative threaded Class 125/150 — verify against the product data sheet before fabrication.

Developed by Bryan Leurquin